Need help?Do you have a question about the Volvo Penta MD30/MS2 and is the answer not in the manual?
General| Brand | Volvo Penta |
|---|---|
| Model | MD30/MS2 |
| Category | Engine |
| Language | English |
Check engine oil and coolant levels before starting the engine.
Understand the function of each ignition key position for starting and operation.
Observe dashboard indicator lights during the engine starting sequence.
Connect glow plugs for approximately 30 seconds during cold starts.
Perform checks after engine start and identify fault indicators.
Stop the engine immediately if fault indicators or alarms appear.
Operate engine at cruising speed and follow emergency stop procedures.
Stop the engine immediately if alarms or abnormal readings occur.
Drive is adjustable for optimal running angle; trim angles for 290 and Duoprop.
How to raise the drive and monitor indicators when operating in shallow water.
How to perform reverse maneuvers, including limitations.
Steps for safely shutting down the engine after operation.
Critical warning: Do not turn off the main switch while the engine is running.
Procedure for draining the fresh-water system, with notes on antifreeze.
Procedure for draining the fresh-water system for D40 models.
Tasks for 100-hour service, including oil and filter changes and level checks.
Tasks for 200-hour service, including oil draining and filter replacement.
Safety warnings regarding main switch operation and battery terminals.
Faults related to engine not starting or stopping.
Troubleshooting irregular running, overheating, or speed issues.
Tracing faults related to coolant, fuel, or air in the system.
Safety warnings about stopping the engine and fire hazards.
Warnings regarding cooling system liquid, frost risk, and drainage.
To Next Page