Replacing the headlight bulbs
Loosen the screw on the underside
of the rim with a screwdriver.
Pull out the bottom part of the rim
slightly
and then lift upwards so
that the retainer catch releases its
grip. (Do not pull the headlight rim
so far forwards that the catch at the
top becomes bent, otherwise water
can penetrate and damage the re-
flector.)
Loosen the three screws retaining
the insert. It is not necessary to
remove these screws completely. The
i
nsert can now be removed by turn-
i
ng it in an anti-clockwise direction.
Loosen the small springs retaining
the above holder and remove it.
Take out the bulb holder and loosen
the bulb by pressing it inwards and
turning it in a clockwise direction
at the same time. When fitting a
new bulb, remember that the socket
pins have different widths.
When
refitting the bulb holder in the insert
make sure that the small retainer
engages in its notch.
(In the case of Sealed Beam head-
lights, follow the instructions shown
in the pictures 1-5 and disconnect
the contact for the bulb holder,
after which the bulb and holder are
replaced.)
To Next Page
Loading...
