Measures when getting stuck
Step 1 (by operating zig zag/"duck walk")
1 Engage all differential locks with the foot button.
2 Keep an even engine speed and avoid wheel spin.
3 Steer alternately full lock to the right and full lock to the left.
When you have reached full lock in one direction, continue
operating in that direction until the machine is just about to
stop, before turning to full lock in the other direction.
If the machine becomes stationary after 3–4 turns, or if it sinks
deeper, abort and proceed to step 2.
Step 2 (by rocking loose)
1 Release the accelerator to stop the wheels from spinning.
2 Engage the differential locks.
3 Select gear position D and accelerate.
4 Let up the accelerator and brake.
5 Select gear position R and accelerate again.
6 Repeat this procedure until the machine has “rocked” loose.
If the machine still is stuck, abort and proceed to step 3.
Step 3
1 Get towing assistance from a crawler tractor, a loader or an
excavator.
2 If you do not succeed in dumping the load because of the risk
of overturning, make use of a supporting machine during the
dumping operation.
3 Remove the dumped material behind the load body using the
supporting machine.
4 Lower the load body.
5 Allow the assisting machine to lift and push at the rear of the
load body at the same time as the hauler is operated according
to step 1 until it is free.
210
Operating instructions
Measures when getting stuck
To Next Page
Loading...
Need help?
General
