Service and maintenance
Engine 105
Engine oil filters, replacing
Replace the engine oil filters every time the oil is changed, i.e.
every 500 hours.
The filters are of the disposable type, i.e. they cannot be
cleaned, but must be replaced as whole units.
Removing
1 Use a suitable tool.
Installing
2 Fill the filter with oil. Oil capacity of each filter is approx.
1.25 litres (2.6 US pint).
IMPORTANT! It is important that the filters are filled with oil
before they are installed. This is to ensure lubrication
immediately after start.
3 Coat the gasket with oil.
4 Screw on the filter by hand until the gasket just touches the
sealing surface.
5 Then tighten the filter a further 1/2 a turn.
NOTE! Usually it does not help to tighten the filter harder.
After installing
6 Start the engine and check that the gaskets seal. If it does not,
remove the filter and check the sealing surface.
IMPORTANT! After replacing oil filters, the engine must run
at low idling for at least one minute.
Take care of filters/oils/liquids in an environmentally safe way,
see page 91.
1014765
A Full-flow filters
B Part-flow filter
To Next Page
Loading...
