Volvo Trucks North America, Inc. Date Group No. Page
Service Bulletin 4.2004 392 08 13(47)
5 Push-buttons – Press one of the five push-buttons (5)
to recall a preset station. (Use the following procedure
to setup push-buttons.)
•
Locate a favorite station by using SEEK ∇ / (3)
or the TUNE ∇ /
(4) buttons.
•
Press SET (6) push-button. The station frequency
will flash 5 seconds or until set.
•
Press the push-button that you want to establish
for that station.
•
The radio will now return to that frequency each
time that button is pressed.
Note: A total of fifteen stations can be preset –
5 AM, 5 FM and 5 WX.
6 SET – Press the SET (6) button to set a stations
frequency.
7 Clock – If time-of-day is not on the display, press RCL
(7).
•
Press and hold SET (6) button and at the same
time press and hold TUNE
(4) until correct
minute
appears. (Seconds will set to 00 when
adjusting minutes.)
Frequency – If radio is turned on and time is being
displayed, press RCL (7) to display frequency.
Stereo – The radio will automatically switch to stereo
when tuned to an FM station broadcasting stereo, and
the stereo indicator light ST will be displayed.
Note: FADe and BALance controls have a detent position
at the center for a balance of front to rear and left to
right.
8 Balance – The left-right stereo balance is adjusted
by rotating the BAL (8) control in the corresponding
direction from the detent position.
9 FADE – Using the tab behind the BAL control, adjust
the FAD (9) control to the right to fade toward the rear
speakers. Adjust it to the left to fade toward the front
speakers.
10 Treble – Rotate TRE (10) control to the left to decrease
treble; rotate TRE control to the right to increase treble.
11 Bass – Rotate BAS (11) control to the left to decrease
bass; rotate BAS control to the right to increase bass.
Note: Both controls, for bass and treble, have a detent
position at the center for a balance of treble and bass.
12 Tape Player – Insert a tape into the door marked
AUTO REVERSE (12). Insert the tape with the raised
side to the right.
Note: The arrow, in the display window, points in the of
tape play.
13 Fast Forward – To activate fast forward press the right
hand arrow (>>) button (13). Press the left hand arrow
(<<) button lightly to cancel fast forward and return to
play mode.
Fast Reverse – To activate fast reverse press the right
hand arrow (<<) button (13). Press the right hand
arrow (>>) button lightly to cancel fast reverse and
return to play mode.
Program – Press both direction buttons (13) (<< and
>>) simultaneously. The direction arrow will change in
the display window and the player will play the other
side of the tape.
14 Eject – Press EJT (14) button firmly to eject a tape.
Note: When a tape is ejected, the radio becomes
operative. It is not necessary to eject a tape when
leaving the vehicle; a solenoid removes internal
pressure automatically.