Mark out a straight line parallel to the transom at a dis-
tance
of (C), which depends on the transom angle (α).
The exhaust elbow must have at least 50 mm (2")
clearance (A) from the transom. At a height of 415
mm (16") (C) the distance to the transom must be at
least 800 mm (31.5").
NOTICE! Consider the location of reinforcements,
bulkheads etc. It may be necessary to increase the
distance to the transom to provide clearance for the
exhaust elbow.
Drill holes along the lines
Use the template from tool 3594503 Drill jig to drill four
6 mm (0.24") pilot holes on the intersecting lines.
Installation, Volvo Penta IPS
64 47704162 10-2014 © AB VOLVO PENTA
To Next Page
Loading...
