1. Briefly press the button
– the engine stops.
2. Pull the remote control
key out from the ignition
switch.
BLIS – BLIND SPOT INFORMATION
SYSTEM*
If the BLIS' indication lamp illuminates despite
no vehicle being in the blind spot, the cause
could be reflection from wet road surface or
low sun shining into the camera for example.
In the event of a direct fault in the system the
display shows the text Blind spot syst. Ser-
vice required.
The key can remain in a pocket, for example, the
whole time.
LOCK & ARM THE CAR ALARM
– Touch the rear section of one of the outer
door handles (see illustration) or press lightly
on the smaller of the boot lid's two rubber-
ised buttons (see illustration above).
UNLOCK & DISARM THE ALARM
– Grip a door handle and open the door in the
usual way (a glove may prevent the function)
or press lightly on the larger of the boot lid's
two rubberised buttons.
START THE ENGINE
– Depress the brake/clutch pedal and briefly
press the START/STOP/ENGINE button.
SWITCH OFF THE ENGINE
– Briefly press the START/STOP ENGINE
button.
See the owner's manual, section "Locks and
alarm", for more information.
In order to reach the following key positions without the engine starting: Do not depress the brake/
clutch pedal.
0 Unlock the car.
I With the remote control key fully inserted into the ignition switch: Briefly press START/STOP
ENGINE.
II With the remote control key fully inserted into the ignition switch: Press START/STOP ENGINE
for about 2 seconds.
Key position II consumes a lot of current from the battery and should therefore be avoided!
See also the table in the section "Key positions" in the normal owner's manual for the car for
information on the functions/systems that can be used with the engine switched off in different key
positions.
To return to key position 0 from position II and I: Briefly press START/STOP ENGINE.
SWITCH OFF THE ENGINE AND REMOVE
THE REMOTE CONTROL KEY
KEY POSITIONS
KEYLESS* KEY SYSTEM
To Next Page
Loading...
