How do I use the Start/Stop function*?
02
Manual gearbox
Stop the engine: Declutch, move the gear lever into
neutral position and release the clutch pedal.
Start the engine: Depress the clutch pedal.
Automatic gearbox
Stop the engine: Stop the car with the foot brake and then
maintain the brake pressure.
Start the engine: Release foot pressure on the foot brake.
Illuminated button lamp indicates that the function is active.
It is important to understand this function – see
owner's manual.
Collision Warning with Auto Brake and Cyclist and
Pedestrian Detection, which can warn, brake and/or stop
for vehicles, cyclists and pedestrians.
The function is only an aid and does not work in all
situations – for example, it does not see cyclists from the
side and pedestrians who are shorter than 80 cm or who
are partially obscured.
How does the pedestrian protection work*?
02
Calibration is always required after changing tyres or
changed tyre pressure. In the event of lamp illumination
the system needs to be calibrated. Proceed as follows:
With the ignition switched off, inflate all tyres in
accordance with the tyre pressure label on the driver's
side door pillar.
Start the car. In the normal view for the MY CAR
source, press OK/MENU.
Select Tyre pressure > Calibrate tyre pressure and
press OK/MENU.
Recalibration is carried out while the car is being
driven.
How do I calibrate the tyre pressure
monitoring system (TM)*?
01
Downloaded from ManualsNet.com search engine
To Next Page
