86
Locks and alarm
Changing the remote control
battery
If the locks repeatedly fail to react to signals
from the remote control at a normal distance,
the battery should be replaced (type CR
2032, 3 volt).
1. Pull out the key blade.
2. Place the remote control with the
keypad downwards. Remove the screw
(1) using a small screwdriver.
3. Remove the cover.
4. Note how the + and – poles of the
battery are positioned on the inside of
the cover.
5. Pry out (2) and change the battery.
Avoid touching the battery and its
contact surfaces with your fingers.
6. Reinstall and screw the cover into place.
7. Press the key blade back into position.
Ensure that the old battery is disposed of in
an environmentally friendly way.
To Next Page
