09 Maintenance and service
Battery
09
* Option/accessory, for more information, see Introduction.
347
NOTE
Tighten the screws to 30 Nm. Check the
torque with a torque wrench.
Fitting
1. Lower the battery into the battery box.
2. Move the battery inward and to the side
until it reaches the rear edge of the box.
3. Tighten the clamp that holds the battery.
4. Connect the ventilation hose.
> Check that it is correctly connected to
both battery and outlet in the body.
5. Connect the red positive cable.
6. Connect the black negative cable.
7. Press in the rear cover. (See Removal.)
8. Fit the rubber moulding. (See Removal.)
9. Align the front cover and secure it with the
clips. (See removal.)
For more information on the car's main battery
- see page 391.
Eco Start/Stop DRIVe*
Cars with the Start/Stop function are equipped
with two 12 V batteries - one extra powerful
battery for starting and one support battery
that helps during the Eco Start/Stop DRIVe
function's starting sequence.
For more information on Start/Stop - see
page 127.
For more information on the car's main battery
- see page 120 and 391.
Battery Start Support
Cold start
capacity
A
,
CCA (A)
760 180
Size
B
,
L×W×H
(mm)
278×175×
190
150×90×130
Capacity
(Ah)
70 10
A
In accordance with the SAE standard.
B
Largest possible size.
IMPORTANT
When replacing batteries in cars with the
Start/Stop function, the AGM
1
type batter-
ies must be fitted.
1
Absorbed Glass Mat
To Next Page
