02 Locks and alarm
Keyless drive*
02
* Option/accessory, for more information, see Introduction.
55
is pushed straight up and into the open-
ing.
2. Then insert the key blade in the lock cylin-
der and unlock the door.
3. Refit the plastic cover after unlocking.
NOTE
When the driver's door is unlocked using the
key blade and is opened, the alarm is trig-
gered. It is switched off by inserting the PCC
in the ignition switch, see page 64.
Key memory
2
– driver's seat and door
mirrors
PCC memory function
If several people each with a PCC approach the
car, then the settings for seat and mirrors are
implemented for the person who opens the
driver's door.
After the driver's door has been opened by
person A with PCC-A, but person B with PCC-
B shall drive, the settings can be changed in
three ways:
•
Standing by the driver's door, or sitting
behind the steering wheel, person B
presses their PCC's unlock button, see
page 45.
•
Select one of three possible memories for
seat adjustment with seat button 1-3, see
page 81.
•
Adjust seat and mirrors manually, see
page 81 and 103.
Lock settings
The Keyless function can be adapted by indi-
cating in the menu system MY CAR which
doors shall be unlocked, under Car settings
Lock settings Keyless entry - there
select between
All doors unlock, Any door,
Doors on same side and Both front doors.
For a description of the menu system, see
page 202.
Antenna location
The keyless system has a number of integrated
antennae located around the car:
Rear bumper, centre
Door handle, left rear
Cargo area, central and furthest in under
the floor
Door handle, right rear
Centre console, under the rear section
Centre console, under the front section.
2
Only in combination with power driver's seat and power mirrors.
To Next Page
Loading...
