Volvo XC40 Twin Engine - Right-Hand Stalk Switch Operation; Wiper and Rain Sensor Control; Wiper Service Position

RIGHTHAND STALK SWITCH
The right-hand stalk switch controls the wiper blades and the rain
sensor.
–
Move the stalk switch downward to make one single sweep on
the windscreen.
–
Move the lever in steps upwards for intermittent, normal and fast
speeds.
–
Adjust the interval speed using the stalk switch's thumbwheel.
–
Move the stalk switch towards the steering wheel in order to
start the windscreen and headlamp washers, and towards the
instrument panel to start the rear window washers.
Press the rain sensor button to activate/deactivate the rain
sensor. The windscreen wiper stalk switch must be in position
0, or in the position for a single sweep. The rain sensor auto-
matically starts the windscreen wipers based on how much
water it detects on the windscreen. Turn the thumbwheel up/
down for higher/lower sensitivity.
Press for intermittent wiping with the rear window wiper.
Press for continuous speed with the rear window wiper.
Use windscreen wiper service mode when e.g. replacing,
cleaning or lifting the wiper blades. Tap on the
Wiper
Service Position button in the centre display's function
view to activate or deactivate service mode.
03