|8|
Cleaning, Care & Maintenance
• When using the first time, clean the unit with detergent before use.
• Do not scrub the surface with metal brush or hard tools.
• Do not pile the cooker on top of other metal cookware
Maintenance of sealant ring
• Remove residue and dirt from the lid with cleaning
pin.
Rinse it with detergent.
• Wipe after cleaning.
• Insert sealant ring properly in the lid.
Maintenance of regulator
• If the regulator vent pipe is blocked, then turn the regulator clockwise till the
triangle indicator points to the Unload/Cleaning position” ”, Take out the regulator
from the handle and clean. After cleaning, put regulator back to handle by aligning
the indicator to the Unloading/Cleaning position” ”and counter clockwise turn
regulator back to working position.
Note: Do not take out the regulator by force.
Maintenance of safety valve
• Shift the boil-stopping safety valve for several times; meanwhile clean it with water,
make sure it is in good working condition. Check if the safety valve is loose. Clamp it
when it is loose.
Removal of Scorch marks
• Remove scorch with wooden chopsticks or wooden ladle. Do not use metal brush
otherwise the cooker will scratch.
• If scorch is hard to remove, expose it in the sun and dry it. Then soak it in oil. Put
hot water into the cooker when the oil is soaked up. Clean it after a while. Do not use
sharp tools to remove the scorch, it will damage the cooker.
To Next Page
Loading...