Before connecting power to your pedals, verify that they require 9 or 12VDC and standard center
negative polarity. Then use any of the included cables with black plug ends. Otherwise, obtain the
correct cable and voltage adapter if necessary.
(1) X-LINK expansion ports. These power X-series expanders to add more isolated outputs.
(2) LED Status Indicator - Steady ON during normal operation.
(3) 9V/12V isolated DC outputs. Each output supplies up to 500mA @ 12V and 200mA @ 9V.
(4) 9V isolated DC outputs. Each output supplies up to 500mA.
(5) AC power input jack. Standard “IEC-type” connector accepts any mains voltage 100-240VAC.
AVAILABLE DC POWER CABLES AND ADAPTERS
Voodoo Lab can supply cables with different lengths, connectors or polarity. These and many more are
available at voodoolab.com or from your Voodoo Lab retailer.
Output Splitter: Allows two pedals to share a single isolated output. One side is ground lifted to
minimize interaction between the pedals (Part# PPAV)
Voltage Doubler Adapter: Combines voltages of two isolated outputs to power 18V and 24V
pedals (Part# PPAY). Also available as an all-in-one Voltage Doubler cable (Part# PPY)
Current Doubler Adapter: Combines current supply of two isolated outputs to power effects
requiring more than 500mA (Part# PPAP)
Line-6 HX Cable: Combines current of two isolated 9V outs to power Line 6 HX Effects and HX
Stomp (Part# PPHX)
Battery Snap Cable: Powers older vintage pedals without a DC power jack (Part# PPBAT or
PPBAT-R)
Pedal Power Replacement Cable Kit: Complete cable kit for Pedal Power 3 (Part# PPPK-3)
To Next Page
Loading...
