VORAGO BTE-400 - Charger and Battery

ENGLISH
INSTRUCTIONS FOR USE
Fullychargetheheadsetbeforestart.
Charger and Battery
The headset is embedded with non-removable charging
battery.Donotattempttoremovethebatteryfromtheheadset;
otherwise,theheadsetmaybedamaged.Iftheheadsetisnot
usedinalongtime,keepitinadryandwell-ventilatedplace,
andchargetheheadsetonceeverytwomonths.
1.Iftheredindicatorblinkswithavoiceprompt“BatteryLow”,
theheadset batteryislow.Ifthe headsetcontinuesto work,
itmaybeautomaticallypoweredoff.Atthistime,youneedto
chargetheheadsetbyconnectingthecableofthechargerto
thechargingportontheheadset.
2.ConnectthechargertoanACpowersocket.
3.Thered indicatorisonwhentheheadsetisbeingcharged.If
thechargingisnotstartedyet,disconnecttheheadsetfromthe
powersocket,andreconnecttheheadsetagain.Ittakesabout
2hourstofullychargetheheadset.Afterbatterychargingis
completed,theredindicatorisoff,andtheblueindicatorison.
Atthistime,youcandisconnect thechargerfromthepower
socketandheadset.