English
13
Unit is not plugged in. Plug power cord into electrical outlet.
Front Panel may not be properly installed. Remove and reinstall the Front Panel to assure proper placement.
Refer to FILTER REPLACEMENT on page 11.
Household circuit breaker / ground fault interrupter has tripped or blown a fuse. Reset circuit breaker /
ground fault interrupter, or replace fuse. For assistance, contact a licensed electrician.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Unit set to a low speed setting. Adjust to a higher speed setting.
Debris build-up on filter. Check and replace filters.
Airflow is blocked. Remove obstruction.
Unit fails to power on.
Airflow is weak or slow.
Problem Possible Cause and Solution
Follow the steps below when you are ready to store your unit.
1. Unplug power cord and bundle loosely.
2. Lift unit with both hands, using hand holds. Refer to USER
TIPS.
3. Cover, or place back in retail carton if available. This will
prevent the unit from accumulating dust overtime.
4. Store unit in a cool and dry location.
Troubleshooting
Storage
To Next Page
Loading...
Need help?
General
