7
English
- A loose t between wall outlet (receptacle) and plug may cause
overheating and distortion of the plug. Discontinue use of the product in
this outlet. Contact a qualied electrician to replace loose or worn outlets.
- Before moving, repositioning, servicing, cleaning and when not in use, use
the product controls to turn off the power and then unplug. Always unplug
device to avoid possible injury due to remote activation of the product.
To disconnect from outlet, grasp and pull only the plug. Also, power off
and unplug if the product will be left unattended for an extended period
of time or during electrical storms.
SERVICING WARNING—To reduce risk of re, electrical shock and
injury to persons, observe the following:
- Always unplug device before servicing or cleaning to avoid possible
injury due to remote activation of the product.
- Clean your product regularly, only as is instructed in this manual. Prior
to cleaning, turn off the power on your product and unplug. Do not use
gasoline, thinners, solvents, ammonias or other chemicals for cleaning.
Refer to the CLEANING instructions provided.
- Do not open appliance housing while product is plugged in. To avoid risk
of shock, all service and/or repairs must be done by a Vornado Authorized
Service Center.
To Next Page
Loading...
