8
FOR USERS
Heating capacity percentage
Real-time power consumption
display
Wi-Fi connection
Water inlet
Water outlet
1. Power On: Press for 3 seconds to light up screen, then press to power on heat pump.
2. Adjust Set Temperature: When screen is unlocked, press or to display or adjust the
set temperature.
3. Switching of real-time power consumption and heating capacity percentage display：Press
and 5 seconds to switch between real-time power consumption display and heating
capacity percentage display. Real-time power consumption function available for single-
phase only.
4. Mode Selection: Press to select mode.
Auto : adjustable temperature range 12~40°C / 54°F～104°F
Heating : adjustable temperature range 18~40°C / 64°F～104°F
Cooling : adjustable temperature range 12~30°C / 54°F～86°F
5. Turbo/Smart/Silence mode selection:
Press to enter Turbo mode, and screen shows , then press to enter Silence mode,
the screen shows . Press again, the screen shows and return to Smart mode.
6. Timer
The timer function is a 24-hour system, please calibrate with local time.
a. Real time setting: Press for 5 seconds to enter real time setting, press or to adjust
the hour. After completion, press switch to minute setting. And then press to
conrm. During real time setting, you can press once to cancel the setting.
b. Time display
When the machine is off, the time display on the top right corner is real time.
When the machine is on, the real time can be shown 10 seconds if you press timer once.
c. Timer setting
To Next Page
Loading...
General