Tower Fan VO4229
3
Stand:
The stand must be ed to the fan before use.The stand is supplied in two secons, upper and lower. The
lower secon includes a guide for the power cable.
Lay down a so towel or cushion for protecon and stand the fan on its top surface so that the base is visi-
ble. An assistant is helpful to hold the fan steady while the base is being ed.
Place the upper half of the stand onto the base of the fan. This will align with three of the xing pillars on
the base.
Place the lower half of the base over the upper half, ensuring that the power cable is not trapped under the
stand.
Use the four long screws to secure the stand to the fan, then the two
short screws to x the two halves of the stand together.
Tuck the power cord into the guide so that it is held close to the un-
derside and exits through the slot in the side of the stand as shown.
To Next Page
Loading...
