[TIP] The tuner recognizes the pitch of E in any octave. This is
useful if you want to tune to harmonics or tune other musical instruments, such as a bass guitar.
[TIP] Once you tune the 6th string using the tuner function, tune the other strings in reference to the 6th string.
4. Press the VARIATION button again or turn the EFFECTS knob 1 to switch the type of Effect 1; the tuner ends, and the bypass is released.
[TIP] In the VOX MINI GO 50, the tuner ends even if the program is switched.
User programs and Manual mode (VOX MINI GO 50 only)
You can save the tones produced by adjusting the amplifier or EFFECTS knob as user programs A, B, and C. The saved programs can be easily called using
the PROGRAM button (21) or the footswitch.
The power select switch, TRIM, SEND, RHYTHM section, and LOOP section settings cannot be saved in a program.
Each time you press the PROGRAM button, the user programs A, B, and C (green, orange, and red), and Manual mode (LED off) is called in sequence. In
Manual mode, all the knob positions are reflected on sounds as they are.
[TIP] The VOX MINI GO 3/10, which does not provide any user programs, is always in Manual mode .
Saving a program (VOX MINI GO 50 only)
After adjusting the various knobs and buttons on the top panel to create your desired sound, it can be saved (written) as a user program.
[TIP] The saved programs can be called using the PROGRAM button or the footswitch.
1. Hold down the PROGRAM button (21) for at least one second (until the PROGRAM LED starts blinking).
2. Press the PROGRAM button to select the save location. [TIP] To cancel the write operation, press the TIME button (13).
3. Hold down the PROGRAM button for at least 2 seconds (until the LED changes from blinking to lit). The program is saved at the selected location, and
the saved program is selected.
If you switch to another program or turn off the amp before saving the sound that you are creating, the changes that you made will be
lost.
Restoring the factory settings
Here’s how to restore all settings of the VOX MINI GO to their factory-set state.
1. Turn off the power.
2. While holding down the VARIATION button, turn on the amp. After the VARIATION LED blink, release the pressed button.
[TIP] If you decide to cancel initialization at this point, press the TIME button.
3. Hold down the VARIATION button for at least 2 seconds (until the LED changes from blinking to lit).
Initialization is completed, and the amp returns to normal operation.
Never turn off the power while initialization is in progress.
Using the footswitch (VOX MINI GO 10/50)
By connecting the footswitch VFS3 to the FOOT SW terminal (28) on the rear panel, you can control effects, rhythms, and loopers with your foot.
To Next Page
Loading...
