Vremi VRM012001N - Removing Collected Water

Dehumidifier 50, 35, 22 Pint · Operation · 17
REMOVING THE COLLECTED WATER
1. Use The Bucket
When the Bucket is full, remove the Bucket and empty it.
Water Outlet
2. Continuous Draining
Water can be automatically be emptied into a oor drain by attaching the Dehumidier to
a Water Hose with a female threaded end. (NOTE: On some models, the female threaded
end is not included)
IMPORTANT NOTE: Do not use "Continuous Draining" when the outdoor
temperature is equal to or less than 32°F (0°C), otherwise the water will freeze,
causing the Water Hose to block up and the Dehumidier may be damaged.
NOTE:
· Make sure the connection is tight and there is no leaking.
· Lead the Water Hose to the oor drain or a suitable drainage facility.
The drain should be lower than the drain outlet of the Dehumidier in order
to drain properly from the Hose.
· Be sure to run the Water Hose sloping downward to let the water ow out smoothly.
· When the "Continuous Drain" feature is not in use, remove the Drain Hose from the
outlet and reattach the plastic cover tightly to the Continuous Drain Hose Outlet.
Remove The
Plastic Cover
By Counter-
Clockwise
Rotation
Female
Threaded
End
Press The Power Cord Storage
Bracket Into The Rear Cover
Water Hose