4
(3)
1
(4)
(3)
(4)
(1)
(2)
Transportation
Before transporting the cabinet, release the castor locking
devices and remove all obstacles from the intended trans-
portation route. If a power supply cable is provided, dis-
connect the cable and secure it to the model. Transport the
cabinet wherever possible by sliding it on its narrow side.
Apply all force through the vertical round tubes at the corners
of the cabinet, ensuring that this force is not applied at a
height exceeding 1300 mm above the floor. Slide the cabinet
over thresholds and other uneven floor surfaces slowly or lift
the cabinet over these areas. Laden cabinets must be moved
by two persons. After completing transportation, reengage
the castor locking devices. Important: If the mouse pad (1)
is pulled out, do not slide the base (2) back into the body
[Fig. 1].
Caution! If the mouse pad (1) is removed, do not
push the bottom (2) back into the body [Fig. 1].
Caution! The furniture should not be moved when
fully loaded!
Electrification
If electrical devices are placed on or in the model, make sure
that the power supply cable is not live and that the castor
locking devices are engaged. On some models the cables
can be routed through a cable outlet (3) or through a rear
opening (4) in the adjustable shelf inserts or fixed bases.
Do not roll the castors over the power supply cable during
transportation.
To Previous Page
Loading...
