5
Board mini_setup_V1.1.0.exe” to start installation.
Complete the installation, and view the icon of the program on the
desktop.
2. Install the receiver
Plug the USB receiver to the available USB port. And the Program
will find the new hardware and pop-up the Add Hardware Wizard
dialog box. Follow the wizard, find the driver, and finish the
installation.
After the connection, move the mouse pointer to the icon of the Mini
Electronic White Board, the program will present “ ”.
NOTE！！
① The driver is at the folder which you have installed the program to.
② The detailed operations refer to the installation guide(”TopA White
Board mini_Installation guide_V1.1.0.doc”).
IV. Operation manual
1. Start mini board system
Please refer to the installation guide.
2. Screen Calibration
User have to set the touchpad before use it. To open short-cut
Menu, please click right mouse button on the mini electronic white
board icon on the task bar in the lower screen. And select “Screen
Calibration”. Click the coordinate by touch pen point by point to
calibrate coordinate from the PC to the mini white board.
To Next Page
Loading...
Need help?
General