6
6
6
GETTING STARTED
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of the piano, use a
screwdriver to loosen the screw and then open the battery cover.
3. If used batteries are present, remove
these batteries from the unit by pulling up
on one end of each battery.
4. Install 3 new AA batteries following the
diagram inside the battery box. (For best
performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries
are recommended).
5. Replace the battery cover and tighten the
screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in re.
To Next Page
Loading...
Need help?
General
