4
INCLUDED IN THE PACKAGE
• Twist & Play Cube
• 4 Blocks
• Quick Start Guide
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child’s safety.
NOTE:
Please save this Instruction Manual as it contains important information.
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Find the battery cover under the top
panel of the electronic module. Use a
coin or a screwdriver to loosen the screw
and then open the battery cover.
3. If used batteries are present, remove
these batteries from the unit by pulling up
on one end of each battery.
Removing the Packaging Locks:
Rotate the packaging locks 90 degrees
anticlockwise.
Pull out the packaging locks and discard.
To Next Page
Loading...
Need help?
General
