8
4. Attach the Driving Panel Support Post to the bottom of the
Driving Panel, securing the pieces together with the four Small
Screws.
5. Insert the Front Wheel into the bottom of the Scooter Body.
Push until you hear the Front Wheel snap into place.
6. To assemble the Back Wheels in the Scooter position, push the
two Back Wheels together. Shorten the Long Axel by pressing
the rounded end toward the squared off end, then place the
Wheels between the two Wheel Supports on the Scooter. Slide
the Short Axel and the Long Axel through the corresponding
sized holes on the Scooter until you hear the two axels snap
together. Ensure the wheels are secured properly before using
the Scooter.
To Next Page
Loading...
