9
7. To remove the Back Wheels, slide and hold the Wheel Lock
while pulling out the Small Axel. Next, slide and hold the Wheel
Lock and pull out the Long Axel, then remove and separate the
two Wheels.
8. To assemble the Back Wheels in the Tricycle position, slide
the Short Axel through the outside of one of the Wheels, then
through the corresponding hole in one of the Scooter’s Wheel
Supports. Next, press the button on the Long Axel and pull to
extend the axel. Slide the Long Axel through the other Wheel.
Insert the protruding end of this axel through the hole of the other
Wheel Support. Push until it slides into the Short Axel and you
hear the two snap together.
To Next Page
Loading...
