Getting Started
3
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom
of the unit.
3. Open the battery cover.
4. Install 3 new “AA” (UM-3/LR6) batteries into the compartment as
illustrated. (The use of new, alkaline batteries is recommended
for maximum performance.)
5. Replace the battery cover and make sure it is properly secured.
BATTERY NOTICE
• Install batteries correctly observing the polarity signs (+, -) to avoid
leakage.
• Do not mix old and new batteries.
• Do not use batteries of different types.
• Remove exhausted or new batteries from equipment when the
unit will not be used for an extended period of time.
• Do not dispose of batteries in fire.
• Do not attempt to recharge ordinary batteries.
• The supply terminals are not to be short-circuited.
• Only batteries of the same and equivalent type as recommended
are to be used.
We do not recommend the use of rechargeable batteries.
NOTE: If the unit suddenly stops working or the sound becomes weak,
turn the unit off for 15 seconds, then turn it back on. If the
problem persists it may be caused by weak batteries. Please
install a new set of batteries and try the unit again.
To Next Page
Loading...
Need help?
General