Getting Started
Parent unit installation
The package comes with two rechargeable batteries. You can
power up the parent unit by using the two rechargeable
batteries or by connecting it to the mains power. However,
even if the parent unit is connected to the mains power, we
recommend you to also install the rechargeable batteries. This
guarantees the continual operation in case of a power outage.
Power
outlet
Parent
unit power
adaptor
Self-adhesive
strap
To set up the parent unit:
1. Remove the battery compartment cover.
2. Install the supplied rechargeable batteries into the battery
compartment, matching the polarity markings (+ and -).
3. Replace the battery compartment cover.
4. Insert the DC plug of the other power adaptor into the DC
socket on the side of the parent unit.
5. Connect the other end of the power adaptor to a suitable
mains power socket.
6. The Charging LED lights up indicating the parent unit is
charging.
To Next Page
Loading...
Need help?
General
