VTech Care for Me Learning Carrier - GETTING STARTED; BATTERY INSTALLATION; BATTERY NOTICE

5
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover inside the pet carrier.
Use a screwdriver to loosen the screw.
3. Install2new‘AAA’(LR03/AM-4)batteries
following the diagram inside the battery
box.(Theuseofnewalkalinebatteriesis
recommendedformaximumperformance.)
4. Replacethebatterycoverandtightenthe
screw to secure the battery cover.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc)orrechargeable(Ni-Cd,Ni-MH),ornewandusedbatteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeablebatteries fromthe toy beforecharging (if
removable).
• Rechargeablebatteries areonly to be chargedunder adult
supervision.
Getting Started