VTech Count & Learn School Bus - GETTING STARTED; BATTERY INSTALLATION

3
INCLUDED IN THIS PACKAGE
• One VTech
®
Count & Learn School Bus ™ learning toy
• One instruction manual
WARNING: All packing materials, such as tape, plastic sheets,
wire ties and tags are not part of this toy, and should
be discarded for your child’s safety.
NOTE: Please cut the thin thread that
attaches the ball to the bus. The
cut thread can be removed from
the bottom of the bus. Discard the
thread for your child’s safety.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom
of the unit. Use a coin or a screwdriver to
loosen the screw.
3. Install 2 new ‘AA’ (UM-3/LR6) batteries
following the diagram inside the
battery box. (The use of new alkaline
batteries is recommended for maximum
performance.)
4. Replace the battery cover and tighten the
screw to secure.
BATTERY NOTICE
• The use of new alkaline batteries is recommended for maximum
performance.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before
being charged (if removable).
Getting Started