Getting started
5
Deregister handsets
If you want to replace a handset, or reassign the designated
handset number of a registered handset, you must deregister all
handsets that are registered to the telephone base. Then register
each handset individually.
To make deregistration easier, read all of the instructions on this
page before you begin.
To deregister all handsets:
Press and hold FIND HANDSET on the telephone base for
about 10 seconds until the telephone base shows Registering...
Please wait followed by Deregister all handsets?, then release
FIND HANDSET.
Immediately press MENU/SELECT or FIND HANDSET.
The deregistration process takes about 60 seconds to
complete. All handsets alternately show 1.Press FIND HS on
base 4sec and 2.Then press # on handset.
To register the handset(s) to the telephone base again, follow
the registration instructions on the previous page.
You cannot deregister all handsets if any other system handset
is in use.
If deregistration fails, you may need to reset the system and try
again. To reset, unplug the power from the telephone base and
plug it back in.
Even if the battery is depleted, you can still deregister all
handsets by following the steps above. After the handset is
charged for at least 10 minutes, its screen alternately shows
1.Press FIND HS on base 4sec and 2.Then press #
on handset.
•
•
•
1.
2.
3.
4.
To Next Page
Loading...
Need help?
General
