VTech CS6529-24 User Manual

54
Expand your telephone system
Your telephone base can support up to ve handsets. Each handset must be
registered to the telephone base before use. The handsets provided within your
product package are already registered as HANDSET 1 and so forth. You can add
new handsets (CS6509/CS6509-14/CS6509-15/CS6509-16, purchased separately)
to your telephone base. Additional handsets are assigned numbers in the sequential
order they are registered (up to HANDSET 5).
Add and register a handset
When rst purchased, each expansion handset displays To register HS and
See manual alternately. You may need to charge the handset before registering to
the telephone base. For more details on battery charging, see the table on page 4.
To register a handset:
Place the new/non-registered handset in the telephone base.
2. After about 10 seconds, the handset displays Registering... When the registration
process completes, the handset displays Registered and you hear a conrmation
tone. The registration process takes about 90 seconds to complete.
If the registration fails, the handset displays Failed and then To register HS and
See manual alternately, remove the handset from the telephone base and place it
back in. Try the registration process again.
You cannot register a handset if any other system handset is in use.
Only one handset can register to the telephone base at a time.
1.
•
•
Replace a handset
If you want to replace a handset, or reassign the designated handset number of
a registered handset, you must deregister all handsets that are registered to the
telephone base. Then register each handset individually.
To make deregistration easier, read all of the instructions below before you begin.
To deregister all handsets:
Press and hold FIND HANDSET on the telephone base for about 10 seconds until
the IN USE light on the telephone base turns on and starts to ash.
Immediately press FIND HANDSET again. You must press FIND HANDSET
while the IN USE light is still ashing. The IN USE light ashes for approximately
ve seconds.
All handsets display To register HS and See manual alternately when the
deregistration process completes. The deregistration process takes about
10 seconds to complete.
To register the handset(s) to the telephone base again, follow the registration
instructions on the previous page.
You cannot deregister all handsets if any other system handset is in use.
If deregistration fails, you may need to reset the system and try again. To reset, unplug
the power from the telephone base and plug it back in.
Even if the battery is depleted, you can still deregister all handsets by following the steps
above. After the handset is charged for at least 10 minutes, the handset alternately
shows To register HS and See manual.
1.
2.
3.
•
•
•
Do not place the handset
in the charger.
Appendix

VTech CS6529-24 Specifications

General

Brand	VTech
Model	CS6529-24
Category	Cordless Telephone
Language	English