EN - 13
English
Handset battery installation
To install or replace the handset battery, follow
the steps below.
1. Use a narrow object to pry open the screw
cover and remove the screw with cross head
screwdriver. Then, insert a 5 mm standard
flat head screwdriver in the provided slot
and gently open the handset cover.
2. Unplug the battery connector from the
socket and then remove the battery from the
handset battery compartment.
3. Plug the battery connector securely into
the socket inside the handset battery
compartment. Place the battery with the
label THIS SIDE UP facing up and the wires
inside the battery compartment.
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
BT183342/BT283342 (2.4V 400mAh Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine CR1535
THIS SIDE UP
4. To replace the handset cover, align all
the tabs on the handset cover against the
corresponding grooves on the handset, then
firmly push downward until all the tabs lock
in the grooves. Then install the screw.
5. Bend a small paperclip and gently insert it
to the Handset battery ON pinhole to turn on
the handset.
• Without turning on the handset, the
handset cannot be charged or operate.
• The battery is fully charged after 16
hours of continuous charging. For best
performance, keep the cordless handset
in the telephone base when not in use.
• There may be a risk of explosion if a
wrong type of handset battery is used.
Use only the supplied rechargeable
battery (BT264392/BT266342) or
replacement battery (BT266342). To order
a replacement, call 1-888-907-2007.
• FCC ID is shown on the back of the
cordless handset body after the handset
cover is removed.
• Dispose of used batteries according to
the information in "The RBRC® seal" on
page 29.
Handset battery charging
The battery must be fully charged before using the
cordless handset for the first time. The CHARGE LED
turns on when the cordless handset is charging on
the telephone base. The battery is fully charged
after 16 hours of continuous charging. For best
performance, keep the cordless handset in the
telephone base or charging stand when not in
use.
To Next Page
Loading...
Need help?
General
