EN - 3
English
instructions. Improper adjustment of
other controls may result in damage
and often requires extensive work by
an authorised technician to restore the
product to normal operation.
• If the product has been dropped and
the telephone base and/or handset
has been damaged.
• If the product exhibits a distinct change
in performance.
15. Avoid using a telephone (other than
cordless) during an electrical storm.
There is a remote risk of electric shock
from lightning.
16. Do not use the telephone to report a
gas leak in the vicinity of the leak. Under
certain circumstances, a spark may be
created when the adapter is plugged into
the power outlet, or when the handset is
replaced in its cradle. This is a common
event associated with the closing of any
electrical circuit. The user should not plug
the phone into a power outlet, and should
not put a charged handset into the cradle,
if the phone is located in an environment
containing concentrations of flammable
or flame-supporting gases, unless there
is adequate ventilation. A spark in such
an environment could create a fire or
explosion. Such environments might
include: medical use of oxygen without
adequate ventilation; industrial gases
(cleaning solvents; petrol vapours; etc.);
a leak of natural gas; etc.
17. Only put the handset of your telephone
next to your ear when it is in normal talk
mode.
18. The power adapters are intended to
be correctly oriented in a vertical or
floor mount position. The prongs are not
designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or
cabinet outlet.
19. Use only the power cord and batteries
indicated in this manual. Do not dispose
of batteries in a fire. They may explode.
Check with local codes for possible
special disposal instructions.
20. In wall mounting position, make sure to
mount the telephone base on the wall
by aligning the eyelets with the mounting
studs of the wall plate. Then slide the
telephone base down on both mounting
studs until it locks into place. Refer to the
full instructions in Installation in the user’s
manual.
21. This product should be mounted at a
height of less than 2 meters.
22. Listed PoE (The product is considered not
likely to require connection to an Ethernet
network with outside plant routing).
• Keep small metallic objects such as
pins and staples away from the handset
receiver;
• Risk of explosion if battery is replaced by
incorrect type;
• Dispose of used batteries according to
the instructions;
• Disconnect the telephone line before
replacing batteries;
• For pluggable equipment, the socket-
outlet (power adaptor) shall be installed
near the equipment and shall be easily
accessible;
• The applied nameplate is located at the
bottom of the product;
• The equipment is only use for mounting at
heights <2m.
• Avoid using the battery in the following
conditions:-
To Next Page
Loading...
Need help?
General
