Step 2:
Unsnap A2, lift the Blackboard/Whiteboard (A) with one hand and
move the back legs forward with the other hand. Insert A2 into the slot
on the back of the Supplies Tray (B).
Step 3:
Attach the Buckles of the Supplies Tray (B) to both Easel Hooks of
A2, then push the Buckle Handles inward to tighten them.
GETTING STARTED
BATTERY INSTALLATION
Note: Adult assembly is required for battery
installation.
1. Make sure the unit is turned OFF.
2. Locate the battery compartment on the
bottom of the chalkboard. Use a
screwdriver to open the battery cover.
3. Remove the exhausted batteries and
install 4 new AA batteries as illustrated.
4. Replace the battery cover and tighten the
screws. Do not over-tighten the screws.
To Next Page
Loading...
