VTech DM111 BU User Manual

14
Appendix
Troubleshooting (continued)
The link between the baby unit and the parent unit is lost every now and
then, and I’m experiencing sound interruptions.
Move the parent unit closer to the baby unit (but not less than 1 metre). The parent
unit may be out of range.
Reset the baby unit by unplugging the electrical power to the baby unit. Wait for 15
seconds and plug it back in again. Turn on the baby unit and the parent unit. Allow up
to one minute for the parent unit and the baby unit to synchronize.
Common cure for electronic equipment.
If the audio monitor is not responding normally, try the following (in the order listed):
1. Disconnect the power to the baby unit and the parent units.
2. Remove the batteries from the parent units and then install again.
3. Wait a few minutes before connecting power back to the baby unit and the
parent units.
4. The baby unit and the parent units should turn on when they are powered up.
5. Wait for the parent units to synchronize with the baby unit. Allow up to one minute
for this to take place.
•
•
•

VTech DM111 BU Specifications

General

Brand	VTech
Model	DM111 BU
Category	Speaker System
Language	English