11
Appendix
Parent unit battery
When the battery is full, you can expect the following performance:
Operation Operating time
While in standby* mode Up to 8 days
* The parent unit is not connected to the power supply. There is no sound detected
from the baby unit. The standby time varies depending on your actual use and the age
of the battery.
The batteries need to be replaced when:
The parent unit beeps four times every minute.
The batteries are properly installed into the parent unit and the POWER / LINK light
on the parent unit is not on.
LOW BATTERY light ashes on the parent unit.
CAUTION:
To reduce the risk of re or injury, read and follow these instructions:
Use only the AAA alkaline batteries (not included). To order a replacement, visit our
website at www.vtechphones.com or call
1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call 1 (800) 267-7377.
Do not dispose of the batteries in a re. Check with local waste management codes
for special disposal instructions.
Do not open or mutilate the batteries. Released electrolyte is corrosive and may
cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.
Exercise care in handling the batteries in order not to create a short circuit with
conductive materials.
Charge the batteries identied for use with this product only in accordance with the
instructions and limitations specied in this manual.
Observe proper polarity orientation between the battery and metallic contacts.
To prevent re or shock hazard, do not expose this product to water or any type
of moisture.
•
•
•
•
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General
