Baby unit installation
You can power up the baby unit by connecting it to AC power.
Install the baby unit as shown below.
Make sure that the power outlet is not controlled by a wall switch. Bundle the
power adapter cord neatly with a twist tie.
The baby unit turns on when it is powered up.
Use only the power adapter supplied with this product. To order a
replacement, visit our website at www.vtechphones.com or call
1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call
1 (800) 267-7377.
The power adapter is intended for a vertical or oor mount position. The
prongs are not designed to hold the plug in place if it is plugged into a ceiling,
under-the-table or cabinet outlet.
Make sure the baby unit and the power adapter cord are out of reach of
children.
•
•
•
Baby unit
Power outlet not
controlled by a
wall switch
Power adapter
To Next Page
Loading...
Need help?
General
