VTech DS6151 A - California Energy Commission Battery Charging Testing Instructions

87
Appendix
$BMJGPSOJB &OFSHZ $PNNJTTJPO CBUUFSZ DIBSHJOH UFTUJOH
JOTUSVDUJPOT
This telephone is set up to comply with the energy-conserving standards right out of the box.
These instructions are intended for California Energy Commission (CEC) compliance testing only.
When then CEC battery charging testing mode is activated, all telephone functions, except battery
charging, will be disabled.
5PBDUJWBUFUIF$&$CBUUFSZDIBSHJOHUFTUJOHNPEF
When the phone is not in use, press .&/6,

, , , , , , ,  and then the left softkey on the
telephone base.
The CEC battery charging testing mode will be activated in about 60 seconds. You hear a
confirmation tone from the telephone base.
When the phone successfully enters the CEC battery charging testing mode, all cordless
handsets will be deregistered. Then all handsets show Press [HOLD] on base for 4 sec,
then press [#] on handset.
When the phone fails to enter this mode, repeat the steps above.
5PEFBDUJWBUFUIF$&$CBUUFSZDIBSHJOHUFTUJOHNPEF
Unplug the telephone base power adapter from the power outlet, then plug it back in. Then the
telephone base is powered up as normal.
Register the handset back to the telephone base. See page 72 for handset registration instructions.
1.
2.
1.
2.