Quick start guide
for models DS6321/DS6322
Install the telephone base
Install the telephone base and charger(s) as
shown below.
Battery installation and charging
Install the battery as shown below. For optimal
performance, charge the handset battery for at
least 16 hours before use.
If the battery
compartment cover
is on the handset,
press the indentation
and slide the cover to
remove.
1. Plug the battery
connector securely
into the socket
inside the handset
battery compartment,
matching the color-
coded label.
2.
Place the battery with
the label THIS SIDE
UP facing up and the
wires inside the battery
compartment.
3. Align the cover at
against the battery
compartment, then
slide it towards the
center of the handset
until it clicks into place.
4.
Charge the handset
by placing it in the
telephone base or
charger. The CHARGE
light is on when the
handset charges.
5.
CHARGE
light
Telephone line cord
DSL filter (not
included) is required
if you have DSL high
speed Internet service
Telephone
base power
adapter
Electrical outlet not
controlled by a wall switch
Telephone wall jack
Telephone base
Power
adapter
Charger
Electrical outlet
not controlled by
a wall switch
Use only the power adapters and batteries supplied
with your VTech telephone.
For complete feature instructions, please refer to your
user’s manual.
•
•
Using Bluetooth for calls
Pair up to four Bluetooth enabled cell phones with
the telephone base. A maximum of two cell phones
can be connected to make and receive cell calls.
However, only one cell phone can be on a call at
a time.
Minutes are deducted from your cellular plan for the
duration of all cell calls using the DS6321/6322.
Charge your cell phone while it is connected to
the telephone base. Your cell phone’s battery
discharges faster while it is connected to the
telephone base via Bluetooth wireless technology.
If you have voicemail service on your cell phone,
unanswered calls to your cell line are answered by
your cell phone’s voicemail.
Bluetooth wireless technology operates within a
short range (a maximum of approximately 30 feet)
from the telephone base. Keep connected cell
phones and headset within this range.
If you are on a call using a cordless system handset
on the cell line, you cannot pick up the paired cell
phone and join the call. However, you can join the
call using another DS6321/6322 handset.
You cannot use the cell line and a Bluetooth
headset at the same time.
If your cell phone has poor reception in your home,
the DS6321/6322 cannot improve the reception.
However, if there is a location in your house with
better reception, you can leave your cell phone at
that location while you use the DS6321/6322 cell
line. In order for this to work, the telephone base
must be within 30 feet of the cell phone.
If you have difculty using your cell line, refer to
the Troubleshooting section of the user’s manual.
•
•
•
•
•
•
•
•
Make, answer and end a call
You can make and receive calls using the home and
cell lines. The home line is your conventional telephone
land line ( /HOME/FLASH). The cell line is the
telephone line associated with your cell phone service
( /CELL).
You can:
Use the home and cell lines at the same time.
Conference the home and cell lines.
To make a home call:
Press /HOME/FLASH or , then enter the
telephone number.
To predial a home call:
Enter the telephone number, then press
/HOME/FLASH or .
To answer a home call:
Press /HOME/FLASH or .
-OR-
Press the call key on your headset if you have a
Bluetooth headset connected.
To end a home call:
Press OFF/CLEAR or put the handset in the
telephone base or charger.
-OR-
Press the call key on your headset if you are using
your headset.
•
•
•
•
•
•
To Next Page
Need help?
General
