VTech Hover Pup - GETTING STARTED; Battery Removal and Installation

4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the two battery covers located on the bottom of the unit,
use a screwdriver to loosen the screws and then open the
battery covers.
3. Remove old batteries by pulling up on one end of each battery.
4. Install 4 new AA batteries following the
diagram inside the battery boxes. (For
best performance, alkaline batteries
or fully charged Ni-MH rechargeable
batteries are recommended.)
5. Replace the battery covers and tighten
the screws to secure.
IMPORTANT: BATTERY INFORMATION
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotmixoldandnewbatteries.
• Donotmixalkaline,standard(carbon-zinc)orrechargeable
batteries.
• Onlybatteriesofthesameorequivalenttypeasrecommended
are to be used.
• Donotshort-circuitthesupplyterminals.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.