4
Care & Maintenance
1. Keep your InnoTV™ console and controller out of direct sunlight and
away from direct sources of heat.
2. Turn off your InnoTV™ console and controller when not using it for an
extended period of time.
3. Avoid dropping your InnoTV™ console and controller and NEVER try
to dismantle them.
4. Always keep your InnoTV™ console and controller away from water.
5. Please examine the toy transformer periodically for conditions that
may result in the risk of fire, electric shock, or injury to persons (such
as damage to the output cord, plug pins, housing, or other parts). In
an event of such conditions, the transformer should not be used until
properly repaired.
Cleaning the InnoTV™ Console and Controller:
• Keep your InnoTV™ console and controller clean by wiping them with
a slightly damp cloth. Never use solvents or abrasives.
If your InnoTV™ does not respond to an inserted cartridge, please carefully
try the following:
• Turn off the InnoTV™ console and unplug all wiring.
• Use a cotton bud dipped in rubbing alcohol or an alcohol-based
window cleaner to gently clean the contact area of the cartridge slot.
• If necessary, dry all the clean contact areas with a soft, lint-free cloth.
• Make sure that all parts are completely dry before restoring electricity.
Backup Battery Replacement
• Make sure the console is turned off.
• Locate the battery cover on the back of the console, and then open
it with a screwdriver as shown in the image below.
• Insert a CR2032 battery into the battery compartment with the “+”
side facing up as shown in the image below.
• Make sure to replace the battery cover.
To Next Page
Loading...
Need help?
General
