30
30
Insert the camera into the waterproof case
1. Be sure you have inspected the O-ring (refer to the later section for
details about inspecting the O-ring) and checked for water leaks
before inserting the camera.
2. To avoid water leaking, if you have attached a wrist strap to the
camera, you must detach it before inserting the camera to this
unit.
3. Open the case cover by pulling the buckle handle outwards as
indicated by the direction of the arrow icon below. After the handle
is loosened, the buckle can be opened.
4. When the waterproof case is opened, insert the camera taking note
of the position of the buttons. As a point of reference, the micro-
USB port will be on the same side as the buckle on the waterproof
case.
To Next Page
Loading...
