31
31
5. Close the case cover and the buckle to hold the cover in position.
Push the buckle handle towards the case body to tighten the
buckle.
6. Mount the waterproof case onto the Floating mount. Align the tripod
screw hole on the waterproof case to the screw of the Floating
mount. Screw the nut on the oating mount clockwise to afx the
camera on the mount.
7. Loosen the angle adjustment handle and you can rotate the angle
adjustment arm to adjust the capture angle.
8. Tighten the angle adjustment handle after you set the capture
angle.
9. The camera is now ready for underwater use (up to 6’ / 1.8m).
Notes on use
• This waterproof case is operable up to a water depth of 6’ / 1.8m for
30 minutes with the camera inserted.
• The waterproof performance is in accordance with the current toy
safety standards
• Do not subject this unit to a jet of pressurized water.
• Do not use this unit in hot springs.
• Use this unit in the recommended operation water temperature
range of 32°F - 104°F (0°C to 40°C). Otherwise, moisture
condensation or water leakage may occur and damage the camera.
• Sometimes waterproof performance is lost if this unit is subject to a
strong impact such as from being dropped.
To Next Page
Loading...
