VTech Kidizoom Action Cam HD - Using the Adhesive Mount

38
38
38
7. The camera is afxed on the bike and ready for use. Loosen the
angle adjustment handle and you can rotate the angle adjustment
arm to adjust the capture angle.
8. Tighten the angle adjustment handle after you have set the capture
angle.
Caution: Do not adjust the bike mount / adhesive mount while riding.
Using the adhesive mount
1. Attach the adhesive at mount to the mounting attachment as
illustrated. You can hear a click sound when the attachment is
seated correctly.
2. Ensure the surface that you would like to afx the adhesive mount
on is clean and smooth.
Note: If there is dirt or liquid on the surface or the surface is rough,
the adhesive performance will be affected.
3. Remove the protective cover of the adhesive surface and stick it on
a clean, at and smooth surface.
Note: If the surface is not very at or a bit curved, such as that
of a helmet, add the extra two double-sided adhesive tape strips
(included) onto the adhesive at mount to improve the contact area
between the surface and the adhesive at mount.
Remove the protective covers of the adhesive at mount and the
extra double-sided adhesive tape strips, stick the two tape strips
onto both tips of the adhesive surface of the adhesive at mount
before sticking the adhesive at mount to the surface you would like
to stick it on.
4. Apply rm pressure to the adhesive at mount and the contact
surface, making sure that the surface makes contact over the entire
area.
Note: Maintain this pressure for several minutes to increase the
adhesive bond strength.