39
39
5. It is recommended that the adhesive flat mount stay on the
surface at room temperature for 1 day before using to allow
the ultimate strength to be achieved. At room temperature,
approximately 50% of the ultimate strength will be achieved
after 20 minutes, 90% after 24 hours and 100% after 72 hours.
6. Mount the holder / waterproof case onto the adhesive mount. Align
the tripod screw hole on the camera holder / waterproof case to the
screw of the adhesive mount. Screw the nut on the adhesive mount
clockwise to afx the camera on the mount.
7. Loosen the angle adjustment handle and you can rotate the angle
adjustment arm to adjust the capture angle.
8. Tighten the angle adjustment handle after you set the capture
angle.
Note:
Once the adhesive surface is stuck and afxed to a device, do not tear
it off. Otherwise, the adhesive performance may be reduced and it may
not work well for subsequent use.
The mount can be detached from the adhesive part. Push the
detachable buckle as shown in the illustration to separate the two
parts.
To Next Page
Loading...
