6
6
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
Note: Adult assistance is required for battery installation.
1. Make sure the camera is turned Off.
2. Locate the battery covers on the handles of the camera. Open the
battery covers separately by pressing each trigger inwards.
3. Remove old batteries by pulling up on one end of each battery.
4. Install 4 new AA batteries (2 on each side) as illustrated.
5. Replace each battery cover and make sure it clicks into position.
BATTERY NOTICE
• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-
zinc) or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in re.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging
(if removable).
• Rechargeable batteries are only to be charged under adult supervision.
To Next Page
Loading...
Need help?
General
