VTech Lil’ Speller Phonics Station - Getting Started; Release Try-Me Blocks; Battery Installation; Battery Notice

5
GETTING STARTED
RELEASE THE TRY-ME BLOCKS
1. Make sure the unit is turned OFF.
2. Carefully pull the try-me blocks away from
the toy and cut the strings as illustrated.
3. Then, remove the strings from the front of
the toy.
4. Please insert letter blocks (other than “d”,
“o”, “g”) into the slot before you turn on
the unit to activate normal play.
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom
of the unit. Use a screwdriver or coin to
loosen the screw.
3. Install 2 new “AA” size (LR6/AM-3)
batteries following the diagram inside
the battery box. (The use of new alkaline
batteries is recommended for maximum
performance.)
4. Replace the battery cover and tighten the
screw to secure.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
GETTING STARTED
155000 IM.indd 5
01/14/2014 9:20:26