3
INCLUDED IN THIS PACKAGE
- One VTech
®
Lullaby Bear Crib Projector
TM
- One crib attachment strap
- One instruction manual
WARNING: All packing materials, such as tape, plastic sheets,
wire ties and tags are not part of this toy, and should
be discarded for your child’s safety.
Please loosen the battery cover screws slightly and
remove the wire packaging ties.
GETTING STARTED
BATTERY INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the back of
the unit. Use a coin or a screwdriver to
loosen the screw.
3. Install 3 new ‘AA’ (AM-3/LR6) batteries
following the diagram inside the
battery box. (The use of new alkaline
batteries is recommended for maximum
performance.)
4. Replace the battery cover and tighten the
screw to secure the battery cover.
BATTERY NOTICE
• Install batteries correctly observing the polarity (+, -) signs to avoid
leakage.
• Do not mix old and new batteries.
Instructions & Activities
100000IM.indd 3 12/24/08 12:04:54 PM
To Next Page
Loading...
Need help?
General